6-30V Trigger Delay Cycle Timer 1-Channel Relay Module Circuit Switch
seconds after release to enter mode selection interface; a short time by pressing "UP", "DOWN" key to select the mode (P1.1 ~ U-4). Select the mode (such as P5.3), short press the "SET" button, then the parameter to be set flashes ( "OP" on-time, "CL" off time, "LOP" cycles ( "----" represents infinite loop)), by "UP", "DOWN" keys to adjust the parameter value, support long press (rapid increase or decrease) and short press (increase or decrease one unit); then short press the "STOP" key to select the decimal point position, select the time range (0.01 seconds to 9999 minutes); short press the "SET" button to set the next parameters of the current mode of procedure is as above. After the parameters are set, long press "SET" button for 2 seconds then release, the name of the current.
Jetzt bei Ebay:
